Sewing T-shirt for baby

Lady Bug Dress

Coral Reef Dress - Tutorial

Would you like to make one of these. Come on, lets do it together.

First take any dress pattern ( only body) that fits the little girl you are sewing for and fold it such that one shoulder ( including sleeve opening) gets hidden. Now place this on two layers of fabric ( right sides together). Trace and cut.

Now lets make ruffles and shoulder strap.
Cut a 4 inch wide strip for the ruffle and the length should be twice the measurement of the neckline. Note that since this is off shoulder dress, the neck line means neck+ one shoulder. 
Note that the width of my ruffle strip is much smaller than 4 inches ( and I deeply regretted it). If you want the dress to look exactly like mine, you can keep the width 2.5 inches but I strongly feel that you should go with a wider ruffle.
For the shoulder strap cut a strip about 3 inches wide and 10 inches long. You probably won't need all 10 inches but I usually keep some allowance to adjust it once I try it on the child.
Now on to sewing:

Sew the one shoulder seam, and both side seams of the main body, set it aside:

Now pleat or ruffle the ruffle piece such that the final length is close ( just a little bit more) to the neck-line.

For the shoulder strap just sew the strip across the 10 inches length, right sides together, turn inside out to make a tube.

Now join the shoulder strap to the main body.
Turn the main body inside out, so the right side is outside. Mark the place ( front and back) where you want to put your straps, and decide how long you want it to be. Mine are 7 inches for a one and half year old.
Now pin one end of shoulder strap to the wrong side of body such that the wrong side of the strap is touching the wrong side of the main piece front. Now pin the other end of shoulder strap to the wrong side of 
 back again make sure that the wrong side of the shoulder strap is touching the wrong side of back piece.

Sew over the straps to attach them, do not snip the hanging part of shoulder strap yet, It will help you adjust the fit later on and you can snip it at any point.
Now add the ruffles: pin the ruffle at the wrong of neckline such that right side of ruffle is with wrong side of main  fabric. Sew the ends closed and sew along the neckline to join ruffles to the main body.

Now turn the ruffles over to the right side. The dress is ready to try on. 
If you feel that the shoulder strap is big or small, you can adjust it now by picking out stitches from one of the ends where it has the extra tail and increase or decrease the length. Snip the tail once you're done. If you don't want to add another ruffle, topstitch along the neck line.

Most of the dresses I saw at Gymboree or Gap had only one ruffle, so this tutorial is enough if you want to get that look. For me however it was not working because my ruffle strip wasn't wide enough so I had to add one more ruffle. I'll get to how I did it in a bit, but before that I will show you how to finish the armhole.

Cut a strip of about 15 inches at the bias:

Sew it along the armhole ( right sides together).

Now turn it out, and turn it over the seam into the wrong side of armhole. Topstitch.

Since the knits don't fray I didn't worry about tucking the raw edges in. you may want to do it if you're working with wovens instead of knits.

Now giving the dress some pizzazz:
Cut two strips

S1: 3 inches wides X 40 inches
S2: 2 inches wide X 40 inches

Sew S1 at the longest stitch setting along one side of the strip, do not backstitch. After sewing, pull the bobbin thread from one end, to create a ruffle. Spread the ruffles to evenly space them. Sew this ruffle beneath the ruffle that is already there along the neckline. Make sure that the top ruffle completely covers the seams on this one. Now topstitch the top ruffle along the neckline.

For the ruffle at the hemline, take strip S2 and run a stitch along the center of the length, again at the longest stitch setting. Again pull the bobbin thread to make a ruffle but this time the ruffle has to be only as long as the front hemline. Evenly space the ruffles by hand. Now sew it over the hemline. Since it is a knit fabric, I didn't bother finishing the hems, you may have to do it if you're working with wovens.


Post a Comment

Note: Only a member of this blog may post a comment.