Recycling cartons: Pictures of cereals

A variation on the theme of "family" gift at a picture of cereal ...


... and as an evil, it is the main picture came out bad ((( So, 


Take the cardboard, in principle, its density is not important, important thing to take at least a little thicker than the landscape. I had a box of children's toys 




from her cut, in my case, the square (it could be a circle and a rectangle and a triangle. All that your heart desires). This is the foundation of our future painting. 
Then take a pencil in hand and draw what we want to do. The inspiration for my drawings were henna, but I do not advise to get involved in things too detailed (only if your picture will not be half the size of a wall), otherwise the pattern will get lost and just a bunch of small. 



Next, we need the glue, a brush and buckwheat (even better stock up with tweezers) 



begin process laid out ... 


When I was a photo, I'm a bit wrong, as ye see me first buckwheat, then glue (((And in fact, of course, first you daub glue the part that'll lay out, and then put the top of the croup. 
I advise you to always start from the center, because at some point, you can "zadolbali" do your painting, and then immediately be able to stop it and cut off excess paper, but if you start going outside to do inside, except for any inconvenience, you are depriving themselves of the opportunity to change figure or finish earlier than planned. 
Moving on ... 





After the end of the first phase of buckwheat leaves laid out here is that ... 


then I poured some of buckwheat, which will be the background, but you can do it ... and later 


turn to wheat ... 


In fact, so far We laid out the contours of which are now very easy to fill. Take the glue and pour it into the resulting "pit", and sprinkle on top millet. Then be sure to press lightly with a finger, that would "immerse" in millet glue ... 


This is the way we put our whole Center ... 


Now we begin to make the contours of wheat ... 


So we finish the basic design ... 


More most "hemorrhagic". I decided to make an unusual and vypendritsa frame. Clay "paint" the strip and then trying to post them Tweezers millet. First, make only one direction and then cross 


in the squares formed by investing seed buckwheat (I no longer fits.) better to do the squares of this size, that would always be the same amount of buckwheat, or striking. that somewhere in one grain. And somewhere kuuuuuucha grains from two pieces =)) (da-da. Even two seed lots are beginning to look at the background of one) ... 



then take a little PVA glue and breed him little water (just do not overdo it, enough to make it more liquid.) obtain fluid daubed our picture . We do it for extra strength, plus, I think this should give protection from black flies (it was already here as a post about a picture of cereal. And there were discussing the problem of flies in the picture. You can cover it with paint, but I paint No, but there is glue! So I tried to spread the adhesive, let's see what will come))) 



do not hesitate to smear, the picture should be white. After this procedure, you are likely to be more precise here is 100% run with the bending of cardboard, like you see in the picture. It's not scary. Just put the picture under the press (while it's still wet, ie, immediately after the spreads) and leave to dry so, what would surely leave a couple of days  In principle, further scenarios are large. You can buy a frame with glass and remove the picture under the frame, you can even get the glass and hold a picture in a frame, but I do not what else do not shine, because Money box for no))) That's why I continue my career and make the frame itself. By the way of wooden sticks with me either, so the frame will be low budget - paper and cardboard. And so, take a cardboard cut out another square the same as you did earlier. Are putting it on the other hand pictures and break through a stapler (if your board allows it. I was, as you know, not very thick cardboard, a stapler and I have a normal, small).If you used a cardboard figure is (as I have, figure, of course, is to go into the inner side, that is, if you expand the picture "booty" there must be paper, but not a picture of the box .. 





<corrugated black paper (which included corrugated colored paper), cut strips of desired width and glue on the outside of our pictures on its edge.AKKURANTNO Then with a knife or paring knife, make cuts through, and not from the outside. 






Then bend on these circuits, T . f this happens ... so 



apply the adhesive, and tightened leans clips (cheap and cheerful, you can choose another way) 



then again remove the image to the press. is sufficient to dry completely, I just did in the evening and cleaned up all night.And so, the frame ready, you turn the picture, and what you see? Propleshinki ((( Do not worry, it's not terrible, in fact, it is normal that you have them, you also can not calculate the perfect to the millimeter, how much space will take grits, and as a frame. Calmly take PVA, dripping in his place propleshinok, insert the desired place and grits .. 





Author: zlu_4a 

0 comments:

Post a Comment

Note: Only a member of this blog may post a comment.