Crafty jewelry: bead and paper necklace for Halloween, kids craft ideas

BOO-TIFUL HALLOWEEN CHARM BRACELET

Boo-tiful Halloween bracelet

Crafty jewelry: bead and paper necklace for Halloween, kids craft ideas
The perfect accessory for any Halloween party, these gorgeously ghastly charms really make a statement! These are a great accompaniment to a witch costume or a fun and creative craft for a Halloween party. Making the charms will require help from Mom, but once assembled, they're easy for young crafters to string onto beading elastic.

Supplies: 
Colored pencils or markers
Thin jeweler's wire or craft wire (flexible enough to bend without pliers)
Glue stick or glue dots
Scrapbook paper
Scissors
Pencil (for drawing the charms)
Beading elastic
Pony beads
Drop of craft glue
Here's how:
1. For each charm, cut out matching pairs of miniature Halloween symbols, such as mini pumpkins or skulls (those shown here measure about 3/4 inch to 1-1/4 inches wide/tall). An easy way to accomplish this is to put two squares of paper back to back so you can cut out both at once. Then, your child can use colored pencils or markers to embellish the charms as she likes. You can even create candy corn by gluing strips of yellow, orange, and white paper together, as shown, and then cutting the shapes from it.
2. Cut a 2-1/2-inch length of wire for each charm. Loosely bend each length in half and twist the ends together a few times about 1/8 inch below the bend to form a small loop, as shown. Use glue dots to sandwich the ends of one of these little hangers between the two pieces of each charm. (Trim the wire ends with scissors if they are too long). Firmly squeeze together the two layers of the charm to make sure they are well adhered to the wire and each other.
3. Cut a length of beading elastic that is several inches longer than the circumference of your child's wrist.
4. With each charm, slide a pony bead down over the wire loop so that it rests just above the charm. String the charms onto the elastic, spacing them apart with several pony beads.
5. When the bracelet is the desired length, tightly tie the ends of the beading elastic together with an overhand knot, leaving a little bit of slack so the charms will dangle. Use a dab of glue to secure the knot, if needed. Trim the elastic ends about 3/4 inch from the knot and thread them back through the adjacent beads to hide them.

Source:sheknows.com

0 comments:

Post a Comment

Note: Only a member of this blog may post a comment.